Images may include options
Automatic Clean Finish Elastic Waistband Workstation with Fold-in-Half Stacker
Tunnel Elastic Waistband Station
- Deskills difficult operation
- Auto start-stop
- Auto cut apart
- Automatic fold-in-half stacker
- Parts ready for next operation
- DC electronic motor & microprocessor controls
- Electronic elastic metering
- Automatic piece counter
An electro-pneumatic clean finish waistband station consisting of a multi-needle sewing machine, motor, stand, spiral elastic guide, pneumatic knife (for cut apart) and variable speed conveyor with electronic metering device and fold-in-half stacker.
|Voltage (v/ph/hz)||220v 1ph|
|Air pressure (psi)||90|
|Air consumption (cfm)||10|
Approximately 600 pieces per hour, depending on material and size of parts.
The operator presents the flat garment to the edge guide and into the spiral folder. An electric eye senses the leading edge and starts the sew cycle. The operator holds the garment against the edge guide until completely into the folder. The electric eye senses the trailing edge and stops the sew cycle leaving the proper spacing for the next garment to eliminate waste. The operator then picks up the next garment and repeats. The conveyor will carry pieces to the knife for automatic cut apart and then to the rear fold-in-half stacker. This unit sews and cuts garments apart then folds the garment in half for the side seam operation.
Most industrial multi-needle chainstitch machines.
(Special gauge parts are available)